1/12 roof pitch
Nearly flat — common on low-profile metal and commercial-style roofs
1/12 means 1 inches of rise for every 12 inches of horizontal run — about 4.8° (4.76°).
Builders write it as 1/12 or 1:12. Angle = arctangent(1/12).
When people choose 1/12
- Low-slope metal buildings and sheds where a near-flat look is preferred
- Some carports and lean-tos in mild climates with excellent sealing
- Commercial-style residential additions that must stay under height limits
Metal building notes
On metal buildings, 1/12 is workable only with standing-seam or carefully detailed panels and proven underlayment. Ponding risk is real if the structure settles or gutters clog. Many kit suppliers prefer at least 2/12 or 3/12 for screw-down panels.
Practical notes
Expect slower drainage and stricter flashing details. Snow and ice can sit longer than on steeper roofs. Always confirm manufacturer minimum pitch for your panel type.
Measure with Roof Pitch Finder
Hold your phone plumb, match the roof-shaped guide, and lock 1/12—or whatever your ridge actually is. Free, no signup.
Related pitches
Quick FAQ
Is 1/12 the same as a flat roof?
No. A true flat roof is closer to 0/12 with intentional taper. 1/12 still has about 4.8° of slope—enough for sheet flow when detailing is right, but far less than typical house gables.
Can I put asphalt shingles on 1/12?
Most asphalt-shingle makers require steeper slopes (often 2/12 or 4/12 with special underlayment). Metal or membrane systems are the usual answer for 1/12.
Disclaimer: This page is educational. Roof pitch, snow load, wind, and panel warranties depend on local code, manufacturer instructions, and engineering. Confirm requirements before you build or buy.
Planning a metal building?
After you lock a pitch in the tool, you can optionally request a free metal building quote—no obligation.