3/12 roof pitch
Entry-level gable — a sweet spot for many metal kits
3/12 means 3 inches of rise for every 12 inches of horizontal run — about 14° (14.04°).
Builders write it as 3/12 or 3:12. Angle = arctangent(3/12).
When people choose 3/12
- Residential-looking metal garages and shops
- Barns and agricultural buildings in moderate climates
- House additions meant to look intentional, not flat
Metal building notes
3/12 is one of the most ordered pitches for steel buildings: enough slope for common rib panels, still affordable on wall height and roofing squares. Good default when you are unsure.
Practical notes
Drainage improves vs 1–2/12. You gain a bit of ceiling volume near the ridge. Shingles may still need manufacturer-specific underlayment at this pitch.
Measure with Roof Pitch Finder
Hold your phone plumb, match the roof-shaped guide, and lock 3/12—or whatever your ridge actually is. Free, no signup.
Related pitches
Quick FAQ
Is 3/12 steep enough for shingles?
Many manufacturers allow 3/12 (sometimes 2/12) with ice-and-water shield or specialty underlayment. Read the product sheet—do not assume.
Will a 3/12 metal building match my house?
Only if your house is also low-to-mid pitch. Measure the house with Roof Pitch Finder before ordering a matching lean-to or garage.
Disclaimer: This page is educational. Roof pitch, snow load, wind, and panel warranties depend on local code, manufacturer instructions, and engineering. Confirm requirements before you build or buy.
Planning a metal building?
After you lock a pitch in the tool, you can optionally request a free metal building quote—no obligation.